IOT & Wireless
-
Cable For ESP8266 NodeMCU / ESP32 USB A to Micro USB Cable (1 Meter)
- USB 2.0 A to Micro USB Cable
- Length: 1 meter
₹50₹60In stock
-
ESP32 30Pin Development Board WiFi+Bluetooth (WROOM-32)
- ESP32-WROOM-32 Based Development board
- It supports WiFi, Bluetooth, Bluetooth Low Energy
- Dual Core MCU
- Clock Frequency of upto 240 Mhz
- Upto 512 KB RAM
- Available Peripherals: Capactive Touch, ADCs, DACs, UART, SPI, I2C and more
₹350₹390In stock
-
ESP32 38Pin Development Board WiFi+Bluetooth (WROOM-32)
- Operating Voltage: 3.3V
- DC Current on I/O Pins: 40 mA
- DC Current on 3.3V Pin: 50 mA
- Communication: SPI, I2C, I2S, CAN, UART
- Has on-board enable and reset pins
₹420₹489In stock
-
WeMos D1 R2 WiFi ESP8266 Development Board
- Microcontroller: ESP8266EX
- Operating Voltage: 3.3V
- Digital I/O Pins: 11
- Analog Input Pins: 1
- Based on the ESP-8266EX.
- Arduino Compatible, you can use it on Arduino IDE.
- NodeMcu Compatible
₹350₹380In stock
-
Wemos D1 Mini ESP8266 NodeMcu Lua WIFI IOT Development Board
- Driver IC: CH340
- 11 digital input/output pins
- 1 analog input (3.2V max input)
- Micro USB connection
- Use BRT (Bias Resistor Transistor), easier into flash mode.
- Compatible with Arduino
- Compatible with NodeMCU
- Compatible with MicroPython
₹165₹27039% offIn stock
-
NodeMcu ESP8266 V3 Lua CH340 Wifi Dev. Board
- Uses CH340G instead of CP2102.
- Wireless 802.11 b/g/n standard
- WiFi at 2.4GHz, support WPA / WPA2 security mode
- Support UART / GPIO data communication interface
- A great set of tools to develop ESP8266
- Lowest cost WI-FI
- FOR Arduino like hardware IO
₹180₹30040% offIn stock
-
USB To UART/ESP8266 Adapter Programmer For ESP-01 WiFi Modules With CH340G Chip
- Driver Chip: CH340G
- Supports all basic windows versions.
- Working voltage: 4.5V – 5.5V
- Working current: 300mA
₹100₹120In stock
-
MT76813DBI ESP8266 Serial WIFI Wireless Gain Antenna
- Radome material: polyurethane
- Flexible cable
- Stable signal
- Best for indoor applications.
₹70₹80In stock
-
FS1000A 433mHz Transmitter Receiver RF Radio Module
- Wide input supply (2.5 V to 12V)
- Easy to integrate (V+, GND, and Data)
- The device in deep sleep mode when Data pin is grounded
- Very small dimension.
₹100₹120In stock
-
Infrared IR Wireless Remote Control Module Kit
- Battery: CR2025 160mAh button battery
- Effective angle: 60°
- Sticking material: 0.125mmPET
- Static current: 3uA – 5uA
- Dynamic current: 3mA – 5mA
₹90₹105In stock
-
3.3V Adapter Board For 24L01 Wireless Module
- It can be used with NRF24L01 wireless module
- Add core nRF24L01+ Breakout Adapter with onboard 3.3V Regulator
- Small power on SMD LED indicator
- On-Board Voltage Regulator
₹50₹70In stock
-
ESP-01 ESP8266 Serial WIFI Transceiver Module
- 11 b/g/n Standards
- Wi-Fi Direct (P2P), soft-AP
- 1MB Flash Memory
- Integrated low power 32-bit CPU could be used as an application processor
- A-MPDU & A-MSDU aggregation & 0.4ms guard interval
₹120₹170In stock
-
Ai Thinker LoRa Ra-02 SX1278 433MHz Wireless Spread Spectrum Transmission Module
- Communication distance: 15KM
- Sensitivity: down to -148dBm
- Programmable bit rates: up to 300kbps
- RSSI dynamic range: 127dB
₹430₹490In stock
-
2.4GHz NRF24L01+PA+LNA SMA Wireless Transceiver Antenna
- Voltage: 3-3.6V (recommended 3.3V) V.
- Maximum output power: +20dBm.
- Power-down mode current: 4.2uA.
- Operating Range: 1Km
- Antenna Gain (peak): 2Dbi.
₹180₹450In stock
-
ESP8266 NodeMCU CP2102 Board
- Operating Voltage: 5V
- Input Voltage: 7-12V
- Digital I/O Pins (DIO): 16
- Analog Input Pins (ADC): 1
- UARTs: 1
- SPIs: 1
- I2Cs: 1
- Flash Memory: 4 MB
- SRAM: 64 KB
- Clock Speed: 80 MHz
₹275₹38529% offIn stock
-
RC522 RFID 13.56MHZ Reader Writer Module / MFRC-522 Module with RFID Tag
- Operating Voltage: 3.3V
- Operating Current: 13-26 mA
- Operating Frequency: 13.56MHz
- Communication Interface: SPI protocol
- Reader Distance: less than 5cm
- Data Transfer Rate: 10Mbit/sec(max)
₹90₹150In stock
-
NRF24L01 2.4GHz Wireless Transceiver Module
- Low working voltage: 1.9 to 3.6 V
- I/O input voltage: 5V
- Wireless rate: 1 or 2 MBPS
- SPI interface rate: 0 to 8MBPS
- Transmission distance: 200 meters
- Dimensions: Width: 30 mm, Height: 10 mm, Depth: 20 mm
- Weight: 30 g
₹85₹120In stock
-
HC05 Bluetooth Module
- Bluetooth protocol: Bluetooth Specification v2.0+EDR.
- Frequency: 2.4GHz ISM band.
- Modulation: GFSK (Gaussian Frequency Shift Keying).
- Emission power: =4dBm, Class 2.
₹250₹330In stock
-
NEO6M GPS Module with EEPROM with Antenna
• Operating temperature range: -40 TO 85°C UART TTL socket
• EEPROM to save configuration settings
• Rechargeable battery for Backup
• The cold start time of 38 s and Hot start time of 1 s
• Supply voltage: 3.3 V
• Separate GPS antenna₹300₹400In stock
-
SIM800L GSM GPRS Module Quad-band TTL Serial Port with antenna
• 2G Quad-band 850/900/1800/1900MHz
• Receive and make calls using the speaker and microphone outputs
• Receive and send SMS
• GPRS multi-slot class12 connectivity: max. 85.6kbps(download/upload)
• Operating Voltage range 3.4V ~ 4.4V
• Supports A-GPS
• Low power consumption, 1mA in sleep mode
• Micro SIM Card Slot₹270₹350In stock
-
RF 433MHz Wireless Transmitter Receiver Module (Red)
Features :
- Low Power Consumption.
- Easy For RF-based Application.
- Wide Operating Voltage (1.5-5v)
- ASK Modulation
₹140₹220In stock
